What Factors Affect the Production Efficiency of The Freeze Mill?

Freezing Cryogenic Pulverizer is the product of social and economic development and progress. With the rapid development of China's economy, pulverization technology is also gradually rising. In the production process of the mill, what factors will affect the production efficiency of the frozen mill?

1. Improper operation

When using a Cryogenic Pulverizer Mill, due to insufficient understanding of the working principle of the crusher, improper operation in daily production can not play the normal production performance of the crusher, which affects the production efficiency.

2. The hardness of the material

The harder the material, the harder it is to break, and the more serious the wear on the equipment. The crushing speed is slow, the crushing capacity is small, and the moderate material crushing effect is good.

3. Humidity of materials

When the water content in the material is large, the material is easy to adhere to in the crusher, and it is also easy to block during the conveying process of the material, resulting in reduced crushing capacity and affecting normal production. Strictly control the humidity of materials when selecting materials, and reduce the humidity of materials by sunlight or air drying if necessary.

Freeze Cryogenic Pulverizer

4. The fineness of material after crushing

The more broken the material, the higher the fineness requirements, and the smaller the crushing capacity. It can be determined according to the on-site requirements. If there is no special requirement, the fineness of the material is generally set to medium fine.

5. The viscosity of the material

The greater the viscosity of the material, the easier it is to adhere. The material with high viscosity will adhere to the inner wall of the crushing chamber in the crusher. If it cannot be cleaned in time, it will seriously affect the working efficiency of the crusher and seriously affect the normal work of the crusher. Therefore, when selecting materials, it must be noted that the viscosity of the material cannot be too large.

6. Composition of materials

The more fine powders in the material before crushing will affect the crushing because these fine powders are easy to adhere to and affect transportation. Therefore, materials with a large amount of fine powder should be screened in advance, and the fine powder should be selected from the materials as much as possible, so as not to affect the normal operation of the crusher.

7. Hardware equipment

The better the wear resistance of the crushing parts of the crushing equipment (hammerhead, jaw plate), the greater the crushing ability. If it is not wear-resistant, it will affect the crushing ability. In addition, the broken parts of the crusher must be regularly repaired. If it is damaged or damaged, it should be replaced in time to avoid affecting the normal work of the crusher.

In actual operation, adjust the crusher appropriately according to the actual situation to achieve the maximum production efficiency of the crusher and release more production capacity. You can also refer to the hardware equipment of the Powder Mixer Mixing Machine.